PFEA112-65 3BSE050091R65 Controller using area

PFEA112-65 3BSE050091R65 Controller using area

・ Take note that traces of sheet metal processing be left in our power supplies. ・ When disposing product, follow disposal laws of each municipality. ・ Published EMI (CE, RE) or immunity is the result when measured in our standard measurement conditions and might not satisfy specification when mounted and wired inside end-user equipment. Use the product after sufficiently evaluating at actual end-user equipment. ・ When exporting our products, apply for necessary permissions as required by rules and regulations of Foreign Exchange and Foreign Trade Control Act. ・ Catalogue, contents of the instruction manual may be changed without a prior notice. Refer to latest catalogue or instruction manual. ・ Reproduction or reprinting the instruction manual or its portion is forbidden without our permission.< Criterion of warm up voltage condition > (1)Implementation period : 1 year or above after the delivery (2)Electrical continuity condition Input voltage : Rating Load : 0A Ambient temperature : Normal temperature Time : 30 minutes or more

LONG-TERM STORAGE METHOD AND PERIOD 

・ Please keep the product in carton box. ・ Please do not apply excessive vibration, shock or mechanical stress applied directly to the product. ・ Please keep away from direct sunlight. ・ For long-term storage temperature and humidity, the following conditions shall be used as a guideline : Temperature range : 5oC～30oC Humidity range : 40%～60%RH Please keep away from the places where temperature and humidity can change drastically. It can cause condensation on the product or deterioration. ・ For long-term storage period, we recommend to use within 2 years after receiving the product. There is tendency that the leakage current of an aluminum electrolytic capacitor may increase when stored without using for a long time. This phenomenon can be improved by applying voltage to the aluminum electrolytic capacitor to reduce the increased leakage current through the self-recovery effect of the electrolyte. For reference, before using products that have been stored for a very long time, please warm-up first for 30 minutes or more without taking load.

Terminal Explanation 

Please pay extra attention to the wiring. Incorrect connection will damage the power supply. · When connecting input and output wiring, input AC-Line should be off. · Input wiring and output wiring shall be separated, otherwise noise susceptibility of power supply unit will be weak. · The protective earth (PE) must be connected to the instrument chassis and the chassis of this power supply unit. · Remote sensing lines shall be twisted or use the shielded wire. · Remote ON/OFF control lines shall be twisted or use the shielded wire.CN01, CN02 Connector pin configuration and Function CN01, CN02 pin configuration and function are the same. They are connected to each other in this power supply unit. When the pin of CN01 side is shorted the same function pins of CN02 side are shorted. Please note that the function cannot be separately set with CN01 and CN02.

In the following cases, the output is shut down. When CNT and TOG is opened. When PV and REF is opened.