GE IC698CPE040 Gas turbine control

GE IC698CPE040 Gas turbine control

In advanced applications, a single output from the IMDSO14 digital output module can control up to nine relays. Each I/O module can control up to 18 interconnected termination units. Figure C-2 shows the internal circuitry of dipshunt sockets XU01 and XU02. There are two ways to configure the NTDO02 termination unit. Use either dipshunts or insert an adapter plug (part number 1947690
16) into the dipshunt socket. Figures C-3 and C-4 show two configuration examples. Figure C-3 shows an I/O module with each output controlling a relay. Figure C-4 shows an example of an I/O module controlling 27 relays via four termination units using adapter plugs. In the example shown in Figure C-4: • I/O module output one (group A) controls nine relays. • I/O module output two (group A) controls three relays. • I/O module output ten (group B) controls eight relays. • I/O module output eleven (group B) controls seven relays.

I/O MODULE SELECTION 

(XU03 THROUGH XU10) Dipshunts XU03 through XU10 determine the type of I/O module used. Dipshunts XU03 through XU10 must be configured identically for each relay being used on all termination units connected to a particular I/O module. Table C-2 shows the settings for dipshunts XU03 through XU10 for the IMDSO14 module. When using the adapter plugs, jumper the I/O module outputs to the appropriate relays by soldering wire (22 to 30 gage) on the adapter plug and then inserting the adapter plug into the dipshunt socket (XU01 or XU02)..

NOTE: To use any output on interconnected termination units, the corresponding dipshunt must be configured and installed on all preceding interconnected termination units. For example, if there are three interconnected termination units, XU09 on all three termination units must have a configured dipshunt installed to use output seven on the last interconnected termination unit. Install a configured dipshunt in XU09 and XU10 to use output eight on any NTDO02 termination unit. Configuring XU09 connects 24 VDC to XU10.

The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on