MVME2100 controller card

Crank Delay

 • Time between Engine Crank Attempts. 

• This Delay is started when in the Spindown mode and the speed of the generator set has dropped below 50 rpm. Cannot restart engine until this time has expired. 

Crank Repeats 

• Number of times EGCP-2 will repeat its attempt to start the engine. Cranking attempts will equal the value of Crank Repeats +1. Crank Fail

 • Alarm Set Point.

 • Activates when the Number of Crank Repeats is depleted

Idle Speed

 • If the Relay #12 output is configured for Idle/Rated switch, this value will set the speed at which the Idle/Rated Time begins. 

• Value should be approx. 10% less than the actual idle speed of the generator set. 

Idle Time 

• The delay in seconds the EGCP-2 waits once the Idle/Rated Speed set point is exceeded. Once the Idle/Rated Time is passed, the EGCP-2 will energize the #12 Discrete Output (if the Relay #12 output is configured for the idle/rated function).

Cooldown Time 

• Time allowed for cooldown once engine achieves a stop cycle. 

• Must exceed Cooldown Limit (see next display) before activated. Cooldown Limit 

• kVA set point at which, when exceeded, will cause the engine to go to a cooldown during the next stop cycle.

Engine Run Time

 • Hours of Run Time on Engine

 • Increments every run hour on System Status screen display.

 • Retained in non-volatile memory—Does not require power to retain its value. The memory is updated every 4 hours of continuous operation, and every time the engine is stopped.