The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

NI SCXI-1121 General input mold piece

Generic input module is used for the SCXI 4 channel SCXI - 1121 designed for need to isolate sensor and signal input and design. It provides independence can be configured for each channel isolation amplifier, filter device and the excitation source. SCXI - 1121 can be collected strain, resistance temperature detection device (RTD), thermoelectric coupling, millivolt, voltage and current input signal. In addition, SCXI ‑ 1121 channels can use multiple complex single channel data acquisition device, you can also by adding mold piece to increase the channel number. SCXI ‑ 1121 also provides a parallel mode.

On the Memory tab, drag the slider to divide into Storage and Program memory. The amount of memory allocated to and used by each area is shown in the dialog box. The blue bar indicates the current amount of unallocated SDRAM and determines the boundaries within which the slider can move. 3. Tap OK to apply the new setting. 4. To save the settings, run the Backup utilityAppendix A Product Certifications & Installation Guidelines for Conformance The QuickPanel+ operator interface is intended for use in industrial environments and when properly installed shall comply with the following agency approvals.

Government Regulations 

The FCC requires the following note to be published according to FCC guidelines: Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Changes or modifications to this unit that are not expressly approved by GE Intelligent Platforms could void the user’s authority to operate the equipment. Industry Canada requires the following note to be published: Note: This Class A digital apparatus complies with Canadian CAN ICES-3 (A)/NMB-3(A).