ABB KUC755AE117 3BHB005243R0117 Excitation module

The boot software for the gate array will take these values after reset to initialize the gate array. The FGA command may be used to enter an interactive node for changing this boot table in the battery-buffered SRAM. The FGA command will show the actual value stored in the battery-buffered SRAM. To change any value, a new one has to be entered in binary format. If only ais entered, no change will be made. To step backwards a minus has to be entered. If a <.> oris given, the FGA command returns to the shell. Note: The command uses cursor positioning codes of the selected terminal. Use the ST command to set the correct terminal.This command • flushes all modified hashing buffers for disk writing or • sets the time interval in seconds when an automatic flush should be performed. If no argument is entered, all modified hashing buffers are flushed. If a disk number and time value are given, the time interval of the automatic flush is set.

RUNNIRAM - Run VMEPROM in RAM 

Format RUNNIRAM destination-address This command provides an easy way to copy the VMEPROM software from the system flash memory into the DRAM to run it there. First, the binary image of VMEPROM will be copied to the specified destination-address, then all absolute addresses of the image will be relocated. Finally, VMEPROM will completely be restarted at its new location. Automatic copy It is possible to let VMEPROM automatically copy its image into RAM after reset. After copying, the image is located at the end of memory and VMEPROM runs there. To enable automatic copy, use the FGA Boot SETUP command to set the Application Flags to 000116 (see “SETUP – Change Initialization Values” on page 185). Per default VMEPROM runs in the system flash memory.

SELFTEST - Perform On-Board Selftest 

Format SELFTEST This command performs a test of the on-board functions of the CPU board. It can only run if no tasks are running. If there are any other tasks, they are automatically killed before running the selftest. SELFTEST tests the memory of the CPU board and all devices on the board. The following tests are performed in this order: 1. I/O test This function tests the access to the IOC registers, the SCSI controller and tests both CIO devices. CIO #1 and CIO #2 will be tested if they are able to generate vector interrupts via a timer. If tests fail, error messages will be printed to state the type of fault.

Superior products

Main products include DCS control system spare parts, PLC system spare parts and robot system spare parts,

Advantage brands: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, B&R, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft and other imported industrial parts

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.