ABB AO2000 LS25 controller module

Maximum wire cross section that can be connected: 2.5 mm2 The motors are equipped with a PTC resistor for monitoring the temperature. The connection leads are contained in the motor power cable. If the MKD motor is equipped with a holding brake, a DC +24 V (± 10 %) voltage supply must be connected to X5/5.6. The current consumption of the holding brake can be found in the motor documentation ( see page 3 of the supplementary documentation), beacuse the current consumption is dependent on the type of motor. Note: The holding brake of MKD motors is not intended to be a service brake. It is worn out after approx. 20,000 revolutions against the closed brake armature plate

X7 motor power connection

 Maximum wire cross section that can be connected: 4 mm2 Maximum cable length: 75 m Mount the entire shield of the motor power cable to the drive controller using the screw (at the bottom of the unit, see Fig. 4-12). WARNING No warranty! Use of non-INDRAMAT cables voids the warranty for the entire drive system. ⇒ Use only INDRAMAT cables!

X9 DC bus connection 

Maximum wire cross section that can be connnected: 4 mm2 DC bus connection for connecting: an auxiliary bleeder module BZM01.1 - or - an auxiliary capacitance module CZM01.1 - or - additional DKC drive controllers For connection assignments, please refer to the overall connection diagram Fig. 4-13. The connection diagrams are located with the respective additional components.

When planning the fiber optic cable ring, please consult the description "Fiber Optic Cable - Handling" (see pg. 3 of the supplementary documentation). In it you will find a list of fiber optic plugs, cables and accessories. The fiber optic plugs for X10 and X11 are not included in the drive controller.

Superior products

Main products include DCS control system spare parts, PLC system spare parts and robot system spare parts,

Advantage brands: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, B&R, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft and other imported industrial parts

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.