ABB PFTL201DE weighing sensor

Mounting Location 

The SGM□H servomotor is intended for use indoors. Use in an environment meeting the following conditions. 

• Indoors, in a location free from corrosive or explosive gas. 

• A location with good ventilation, with little dust, grime, or steam

 • A location with an ambient temperature between 0~40°C 

• A location with a relative humidity of 20%~80%, no condensation • A location easy to inspect and clean

Alignment Upon mating to the machine, make sure the motor shaft core and the machine shaft core are coupled in a straight line. Mount the servomotor so that it falls within the alignment accuracy in the figure below (1) Improper alignment can lead to vibration, which risks damaging the shaft coupling. (2) When mounting the coupling, do not apply shock directly to the shaft. This may damage the encoder mounted on the shaft end opposite the load

Mounting Direction

 The SGM□H servomotor can be mounted in either the horizontal or vertical directions. ■ Shaft Tolerance Ranges Design machine systems so that the thrust loads and radial loads1 applied to the servomotor shaft during operation fall within the tolerances in Table 3.1. The allowable radial loads shown in the table are the maximum loads that can be applied to the end of the output shaft.

Oil and Water Countermeasures 

It is possible to take protective measures for motor operation in areas where water or oil may drip. However, use a motor with an oil seal attached when needed to set through to the shaft section1 . In addition, mount the motor with the connectors facing downward.Cable Stress Do not bend or stretch the power line. In particular, be careful to wire the signal cable so that they are not subject to stress because its core is very thin (0.2, 0.3mm).

Do you want to know about our products?

We have a large amount of inventory and high quality, out of production control system components, DCS system accessories, robot system accessories, large servo system spare parts. PLC module, DCS module, CPU module, IO module, DO module, AI module, DI module, network communication module, Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output module, redundancy module, power module, relay output module, relay input module, processor module and other major brands.