GE DS3800HFPB1F1E Gas turbine serial card

Replacing the Battery Replace the battery within 40 hours if a battery alarm occurs. If it is within 30 minute after turing on the electricity after the power was turned off for more than 2 days, replace the battery immediately. (The battery alarms appear on the programing pendant display and LED on the system control board is turned on.) Replacement Procedure 1. Disconnect the battery connector (BAT) and remove the battery. 2. Mount the new battery and connect the battery connector. Although the CMOS memory is backed up by super capacitor, the battery must be replaced as soon as the battery alarm occurs. The job data and other data may be lost if the battery is left for more than 40 hours.

Replacing the JANCD-XCP01† Circuit Board 

Turn off the power before replacing a circuit board. Replacement Procedure 1. Disconnect all cables connected to the circuit board. 2. Undo 2 screws fixing the circuit board and rack. 3. Spread the levers attached to the upper and lower side of circut board up and down respectively and pull out the circuit board forward 4. Pull out the circuit board from the rack. 5. Insert a new circuit board into the slot of the rack with the levers spread. 6. Push the board until it is placed in the same position of other boards. 7. Tighten upper and lower screws. 8. Connect all disconnected cables

The JANCD-XCP01

 circuit board contains important file data (CMOS memory) for the user programs, which is backed up by the battery. Incorrect operations can cause this stored file data to be lost. For more information about the replacement procedure of the JANCD-XCP01† circuit board, refer to “YASNAC XRC INSTRUCTIONS for CPU Circuit Board Replacement Procedure.” If you have not received a copy of this instruction manual, contact your Yaskawa representative. • After turning OFF the power supply, wait at least 5 minutes before replacing a control power unit. Do not touch any terminals during this period. Confirm all monitor lights are turned off. Failure to observe this caution may result in electric shock or injury

[Main Products]

Main products: PLC and DCS system spare parts modules of world famous brands

①Allen-Bradley 1756、1746、1747、1771、1785

②Schneider 140 Series PLC module

③General electric GE  IC693 IC697 IC698 Series PLC module

DS200 DS3800 DS215 IS200 IS215 IS220 Series gas turbine module

VMIVME Control module of series

④Bently：3500 series cards 3500/22M、3500/15、3500/92 And other products

⑤ICS TRIPLEX

⑥ABB Robots. FANUC Robots、YASKAWA Robots、KUKA Robots、Mitsubishi Robots、OTC Robots、Panasonic Robots、MOTOMAN Robots。

⑦EMERSON：Spare parts for OVATION system, WDPF system and MAX1000 system.

⑧ Invensys Foxboro: I/A Series system, FBM (field input/output module) sequential control, ladder logic control, accident recall processing, digital analog conversion, input/output signal processing, data communication and processing, etc. Invensys Triconex: redundant fault-tolerant control system, Zui modern fault-tolerant controller based on triple module redundancy (TMR) structure.

⑨Woodward：505 series governor 9907-164 And other products

⑩Bosch Rexroth：Indramat，I/O module,PLC CPU,Motors, drives and other products.

 ◆Motorola：MVME 162、MVME 167、MVME1772、MVME177and other products.