GE DS200SIOCG1A Digital waveform instrument

Homopolar toroid for the star center of the transformer The rated current of the toroid can be set to 100A, 250A, 400A or 800A by using different combinations of connections. The connection between the homopolar toroid and the terminals T7 and T8 of the terminal box shall be realized using a corded shielded two-wire cable (BELDEN type 8762/8772) with length not exceeding 15 m. Shielding shall be earthed on the CB side and on the current sensor side.Wiring between LV and MV circuit-breakers can be realized by means of a two-pole shielded cable to obtain selectivity between MV and LV as shown in clause 3.3. Due to the very low currents absorbed by the inputs of ABB MV releases, it is possible to reach wiring distance up to 800 meters.

General Information 

The manufacturer accepts no liability for any consequences resulting from inappropriate, negligent or incorrect installation or adjustment of the optional operating parameters of the equipment or from mismatching the variable speed drive (Drive) with the motor. The contents of this guide are believed to be correct at the time of printing. In the interests of a commitment to a policy of continuous development and improvement, the manufacturer reserves the right to change the specification of the product or its performance, or the contents of this guide, without notice. All rights reserved. No parts of this guide may be reproduced or transmitted in any form or by any means, electrical or mechanical including photocopying, recording or by an information storage or retrieval system, without permission in writing from the publisher.

Declaration of Conformity

This electronic drive product is intended to be used with an appropriate motor, controller, electrical protection components and other equipment to form a complete end product or system. It must only be installed by a professional assembler who is familiar with requirements for safety and electromagnetic compatibility (EMC). The assembler is responsible for ensuring that the end product or system complies with all the relevant laws in the country where it is to be used. Refer to the product manual or EMC data sheet for further information on EMC standards complied with by the product, and guidelines for installation.

 Company product range

----------------------Ruichang Mingsheng Automation Equipment Co., Ltd----------------------

PLC module, programmable controller, CPU module, IO module, DO module, AI module, DI module

Network communication module,

Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output

Module, redundancy module, power module, relay output module, relay input module, processor module