GE DS200SHVIG1A Channel isolation card

The way a motor is cooled changes the standstill or nominal current of the motor. All torque/force data of the drive are scaled in per cent values and relate to the standstill and / or nominal current of the motor. To obtain correct torque / force data for the various cooling methods of MDD, MKD and MHD motors, it is necessary to take the cooling method into account when scaling. A factor is defined via parameter P-0-0640, Cooling type that gives the peaking of the standstill and / or nominal currents.This function may only be used by Rexroth Indramat personnel and, for this reason, can only be accessed with the master password. Once the master password is input, then the detection procedure can be started with parameter P-0-0550, B000 Pulse wire / resolver offset detection.

Load base parameters with "PL" If “PL”

 is displayed on the drive display after the drive controller is switched on, then the phases will not run up and communication with the drive controller will not be possible. It is necessary, in this case, to first press the S1 key of the controller. Absolute Encoder Evaluation and Monitoring of Two Absolute Measuring Systems The use of a second absolute encoder back-up now makes it possible to operate two absolute measuring systems without any restrictions. Plausibility checks of the absolute encoder data are now also possible so that any replacement of the encoder will definitely cause the encoder home to be cleared.

Homing with Permanently Defined 

Travel Paths in Distance-coded Encoders It is now possible to home gantry axes with distance-coded linear scales. It was necessary to implement this function because the travel path of distance-coded encoders required to find home was permanently fixed by the distance of the homing mark. The function “Homing with fixed travel path” is activated by setting bit 8 in parameter S-0-0147, Homing parameter. The drive runs over at least two homing marks and then stops regardless of whether it has detected the homing mark or not.

 Company product range

----------------------Ruichang Mingsheng Automation Equipment Co., Ltd----------------------

PLC module, programmable controller, CPU module, IO module, DO module, AI module, DI module

Network communication module,

Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output

Module, redundancy module, power module, relay output module, relay input module, processor module