ABB PM632 Input characteristic module

Installing the Module in the Rack If you have not already installed and configured your SLC processor and power supply, please do so before installing the MVI46-101M module. Refer to your Rockwell Automation product documentation for installation instructions. Warning: You must follow all safety instructions when installing this or any other electronic devices. Failure to follow safety procedures could result in damage to hardware or data, or even serious injury or death to personnel. Refer to the documentation for each device you plan to connect to verify that suitable safety procedures are in place before installing or servicing the device.Warning: This module is not hot-swappable! Always remove power from the rack before inserting or removing this module, or damage may result to the module, the processor, or other connected devices.

After you have checked the placement of the jumpers

 insert MVI46-101M into the SLC™ chassis. Use the same technique recommended by Rockwell Automation to remove and install SLC™ modules.

1 Turn power OFF. 

2 Align the module with the top and bottom guides, and slide it into the rack until the module is firmly against the backplane connector. 

3 With a firm but steady push, snap the module into place. 

4 Check that the holding clips on the top and bottom of the module are securely in the locking holes of the rack. 

5 Make a note of the slot location. You will need to identify the slot in which the module is installed in order for the sample program to work correctly. Slot numbers are identified on the green circuit board (backplane) of the SLC rack. 

6 Turn power ON.

Connecting your PC to the Processor 

1 Connect the right-angle connector end of the cable to your controller at the communications port. 

2 Connect the straight connector end of the cable to the serial port on your computer

Note: If you insert the module improperly, the system may stop working, or may behave unpredictably.

The key switch on the front of the SLC processor must be in the REM position. 1 If you are not already online to the processor, open the Communications menu, and then choose Download. RSLogix will establish communication with the processor.Click the Download button to transfer the sample program to the processor. 3 RSLogix will compile the program and transfer it to the processor. This process may take a few minutes.

 Brand display

 ABB、GE/FUANC、FOXBORO、TRICONEX 、BENTLY、A-B、EMERSON 、MOTOROLA、XYVOM、HONEYWELL 、REXROTH、KUKA、NI、DEIF、Yokogawa、WOODWARD、Reliance Electric、SCHNEIDER 、MOOG、PROSOFT、KOLLMORGEN、ICS TRIPLEX、HIMA。