Home > Product > DCS control system > ABB PM210 3BSE021386R2 Voltage interface module

  • ABB PM210 3BSE021386R2 Voltage interface module
ABB PM210 3BSE021386R2 Voltage interface module

ABB PM210 3BSE021386R2 Voltage interface module

ABB PM210 3BSE021386R2 Voltage interface module

For RLX2-IHNF-W Radios 1. Attach an Ethernet cable with an M12 connector to the specified port shown on the designated Master RLX2 radio. Make sure that this network connection is on the same subnet as the PC running the IH Browser configuration software.2. Connect the power cable with an M12 connector to the specified port shown. Note: The RLX2-IHNF-W radio can be powered over Ethernet (POE) with an approved injector available from ProSoft. In this case, the Power connector would not be used. If PoE is used, please cap the Power Connector with the supplied M12 Waterproof Cap before installation. 3. Connect the Ethernet cable through the PoE injector (if using PoE) and then into the network switch. Note: Most off-the-shelf PoE Injectors work with this unit except for the 802.3at/ PoE+ Injectors

For RLX2-IHNF-WC Radios

 This radio is suitable for Class I, DIV2 hazardous locations. This radio contains a set of wires that protrude through a single conduit hub. One wire is terminated with an RJ45 connector for Ethernet connections. This wire can also supply power if attached to a PoE Injector. The second wire supplies power to the radio if a PoE Injector is not used. If not using these cables, simply terminate them. To install this radio…. 1. Place a Seal Cap over the top of the conduit. 2. Run both wires down through the conduit. 3. Push the conduit up into the permanently installed connector on the bottom of the radio. Push it up as far as it will go.

The wire with the RJ45 

connector is your Ethernet connection and supports Power over Ethernet (PoE). If you are not using PoE, the other wire set is used to power the module. Note: If you are using PoE to provide power to the module, the additional power cables should be terminated inside the junction box during installation to prevent the wire assembly from shorting out. WARNING: Do not connect or disconnect the PoE connection when energized.

                                        

 Brand display

 ABBGE/FUANCFOXBOROTRICONEX BENTLYA-BEMERSON MOTOROLAXYVOMHONEYWELL REXROTHKUKANIDEIFYokogawaWOODWARDReliance ElectricSCHNEIDER MOOGPROSOFTKOLLMORGENICS TRIPLEXHIMA。

Obtain the latest price of ABB PM210 3BSE021386R2 Voltage interface module