ABB PM510 3BSE000270R1 AC power module

Setup Client Radio RLX2 radios can be configured in Client mode. Client mode radios only support one wired network device, but can connect to third-party 802.11 Access Points. The following table highlights the most significant differences between Repeater and Client modes on RLX2 radios Client mode radios are not often necessary in Industrial network applications. If the need for a Client RLX2 radio in the system is not needed, this example configuration can be skipped. The most straightforward way to test a Client mode radio configuration is with a second PC connected as the downstream network device from a Client radio. We will assume such a setup in the following example, and will connect to the Master radio we configured previously.

Connect the client radio to the same network

 as the configuration PC running the IH browser. Assign it an IP address as described above. Open the configuration webpage and change the radio to Client mode as shown:Power off the Client radio and disconnect the Ethernet cable from the configuration PC. 3. Connect the Ethernet cable to an Ethernet port on another PC, and power up the Client radio. (The radio must be powered up after attaching the Ethernet cable to the new PC so the radio will register the MAC address of the PCs network interface.) Ensure the IP address of the Ethernet interface on the PC is on the same subnet as the network of the Client Radio. 

Install Replacement Radio

 Using Personality Module If the radio being installed is replacing an existing radio, and a Personality Module was already installed in the existing radio, then no manual configuration is necessary. Remove the Personality Module from the existing radio with the stored configuration and install it in the new radio. On power up of the new RLX2 Industrial Hotspot, all configuration settings from the radio being replaced are automatically used. Note: The RLX2-IHNF-W or WC radios do not have a Personality Module and must be configured using the steps described in this manual.

 Brand display

 ABB、GE/FUANC、FOXBORO、TRICONEX 、BENTLY、A-B、EMERSON 、MOTOROLA、XYVOM、HONEYWELL 、REXROTH、KUKA、NI、DEIF、Yokogawa、WOODWARD、Reliance Electric、SCHNEIDER 、MOOG、PROSOFT、KOLLMORGEN、ICS TRIPLEX、HIMA。