ABB XVC724BE102 XVC 724B E102 data acquisition module

The radio shall be installed by trained personnel only, as outlined in the installation instructions provided with each radio. The equipment shall be installed by a qualified installer/electrician. The installer/electrician is responsible for obtaining a secured ground connection between the lug terminal on the surge protector to a verified common ground point using a minimum 6 AWG gauge wire. This must be done when attaching power lines to the radio during installation. A solid ground connection should be verified using a meter prior to applying power to the radio. Failing to secure a proper ground could result in serious injury or death as a result of a lightning strike.

Using Power over Ethernet 

(PoE) to power remote devices has several advantages including:  "Carrier Class" Power Over Ethernet System.  Power can be supplied over long distances, up to 300 feet. Power can be available wherever network access is available.  The power supply can be centrally located where it can be attached to an uninterruptible power supply.  The user has the ability to easily power on reset the attached equipment from a remote location.  There is no need to run additional power cabling to the device as power can be supplied over the CAT5, CAT5E, or CAT6 Ethernet cable.  Used for remote mounted radios to save on cost of coax and reduce RF losses.  Built-in Ethernet Surge protection to prevent equipment damage.  Overload and Short Circuit protection

Ethernet Cable Specifications

 The recommended cable is Category 5 or better. A Category 5 cable has four twisted pairs of wires, which are color-coded and cannot be swapped. The module uses only two of the four pairs when running at 10 MBit or 100 MBit speeds. All eight wires are used when running at 1000 MBit speeds. Category 5e or better cable is recommended for 1000 MBit speeds. The Ethernet port on the module is Auto-Sensing. Use either a standard Ethernet straight-through cable or a crossover cable when connecting the module to an Ethernet hub, a 10/100/1000 Base-T Ethernet switch, or directly to a PC. The module will detect the cable type and use the appropriate pins to send and receive Ethernet signals. Ethernet cabling is like U.S. telephone cables, except that it has eight conductors. Some hubs have one input that can accept either a straight-through or crossover cable, depending on a switch position. In this case, ensure the switch position and cable type agree. Refer to Ethernet cable configuration (page 173) for a diagram of how to configure Ethernet cable

Application industry

The products can be used in the following industries: power plant, paper making, steel, mining, rubber, water supply, cement, chemical industry, glass, printing Textile, machinery, plastics, coatings, medicine, hospitals, food, hotels, scientific research institutions