SST SST-ESR2-CLX Actuator control module

At powerup, Network Boot is enabled, and providing the drive and controller numbers encountered are valid, the following message is displayed on the system console: "Network Boot in progress... To abort hit" Following this message there is a delay to allow you to abort the Network Boot process if you wish. To gain control without Network Boot, you can press the BREAK key or the software ABORT or RESET switches. 4. Then the actual I/O begins: the program pointed to within the volume ID of the media specified is loaded into RAM and control passed to it. Network Auto Boot is controlled by parameters contained in the NIOT and ENV commands. These parameters allow the selection of specific boot devices, systems, and files, and allow programming of the Boot delay. Refer to the ENV command in Appendix A. 

Restarting the System 

You can initialize the system to a known state in three different ways: reset, abort, and break. Each has characteristics which make it more appropriate than the others in certain situations. The debugger has a special feature which can be used in the event your setup/operation parameters are corrupted or do not meet a sanity check. This feature: ❏ Is activated by pressing the RESET and ABORT switches at the same time, and releasing the RESET switch before the ABORT switch. ❏ Instructs 187Bug to use the default setup/operation parameters in ROM instead of your setup/operation parameters in NVRAM. Refer to the ENV command (Appendix A) for the ROM defaults.

During COLD reset: 

1. A total system initialization takes place, as if the MVME187 had just been powered up. 2. All static variables (including disk device and controller parameters) are restored to their default states. 3. The breakpoint table and offset registers are cleared. 4. The target registers are invalidated. 5. Input and output character queues are cleared. 6. Onboard devices (timer, serial ports, etc.) are reset, and 7. The first two serial ports are reconfigured to their default state.

2. Pressing and releasing the MVME187 front panel RESET switch initiates a system reset. Reset must be used if the processor ever halts, or if the 187Bug environment is ever lost (vector table is destroyed, stack corrupted, etc.).
   

 About us

We are professional company and we are expert in this business, we have highly experienced production team, or sales team, or purchase team, we have most advanced production line. We are reputable in the market.

Our products

A company specializes in the sales of module spare parts of global famous brands (DCS system) (robot system) (large servo control system). The company's products include distributed control system (DCS), programmable controller (PLC), MOTOROLA MVME industrial module, industrial control communication converter (Anybus), remote output/input module (RTU), industrial computer (IPC), industrial low screen screen (IPC) HMI SCSI (50, 68, 80Pin) AnyBus (Gateway) has become a global sales enterprise of industrial automation spare parts and components