HIMA F8650E Servo signal module

The MVME761 transition module uses a five-row P2 adapter to transfer the synchronous and asynchronous serial, parallel, and Ethernet signals to and from the MVME2600 series VME module. The P2 adapter has a 68-pin female connector (J1) that carries 16-bit SCSI signals from the MVME2600. (To run SCSI devices, you may install an optional front panel extension, MVME761EXT, next to the MVME761. The panel extension supplies both 8- and 16-bit SCSI.) The P2 adapter for the MVME761 also supports PMC I/O via connectors J3 and J4. Preparation of the P2 adapter for the MVME761 consists of installing a jumper on header J5 to enable the SCSI terminating resistors if necessary. Figure 1-17 illustrates the location of the jumper header and connectors.

Hardware Installation

 The following sections discuss the placement of mezzanine cards on the MVME2603/2604 base board, the installation of the complete MVME2603/2604 VME module assembly and transition module into a VME chassis, and the system considerations relevant to the installation. Before installing the MVME2603/2604, ensure that the serial ports and all header jumpers are configured as desired. In most cases, the mezzanine cards—the RAM200 ECC DRAM module, the optional PCI mezzanine (if applicable), and the optional carrier board for additional PCI expansion (if applicable)—are already in place on the MVME2603/2604. The user-configurable jumpers are accessible with the mezzanines installed. Should it be necessary to install mezzanines on the base board, refer to the following sections for a brief description of the installation procedure.

Motorola strongly recommends 

that you use an antistatic wrist strap and a conductive foam pad when installing or upgrading a system. Electronic components, such as disk drives, computer boards, and memory modules, can be extremely sensitive to electrostatic discharge (ESD). After removing the component from its protective wrapper or from the system, place the component flat on a grounded, static-free surface (and, in the case of a board, component side up). Do not slide the component over any surface. If an ESD station is not available, you can avoid damage resulting from ESD by wearing an antistatic wrist strap (available at electronics stores) that is attached to an active electrical ground. Note that a system chassis may not be grounded if it is unplugged

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.

 Superior products

We mainly make spare parts for DCS, PLC, robot control system and large servo system.

Main products: various modules/cards, controllers, touch screens, servo drives.

Advantages: professional off production accessories,

Fast delivery, accurate delivery time,

Main brands include ABB, GE/FANC, FOXBORO, TRICONEX, BENTLY NEVADA, A-B, EMERSON, OVATION, MOTOROLA, XYVOM, HONEYWELL, REXROTH, KUKA, NI, DEIF, Reliance Electric, Yokogawa, WOODWARD, SCHNEIDER, MOOG, PROSOFT and other brands