HIMA Z6011 Control card

This section applies to MVME712M-compatible models of the MVME2603/2604 VME module. With the MVME2603/2604 installed, refer to Figure 1-21 and proceed as follows to install an MVME712M transition module: 1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure. 2. Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME modules.The MVME2600, MVME712-compatible models will be damaged if mistakenly connected to the MVME761 transition modules instead of the correct MVME712 family of boards.In models of the MVME2603/2604 that are configured for MVME712M I/O mode, the pin assignments of VMEbus connector P2 are fully compatible with other transition modules of the MVME712 series.

Remove the filler panel(s) 

from the appropriate card slot(s) at the front or rear of the chassis. (You may need to shift other modules in the chassis to allow space for the MVME712M, which has a doublewide front panel.) 4. Attach the P2 adapter board to the P2 backplane connector at the slot occupied by the MVME2603/2604 VME module. 5. Route the 64-conductor cable furnished with the MVME712M from J2 on the P2 adapter board to J2 on the transition module. Be sure to orient cable pin 1 with connector pin 1.Secure the MVME712M in the chassis with the screws provided, making good contact with the transverse mounting rails to minimize RF emissions. 7. Referring to the user’s manual for the MVME712M (listed in Appendix D, Related Documentation), route the 50-conductor cable to the internal or external SCSI devices as appropriate to your system configuration. Be sure to orient cable pin 1 with connector pin 1.

The SCSI cabling can be configured

 in a number of ways to accommodate various device and system configurations. Figure 1-21 shows a possible configuration for use with internal SCSI devices. For more detailed information on installing the P2 adapter board and the MVME712M transition module, refer to the user’s manual (listed in Appendix D, Related Documentation).Replace the chassis or system cover(s), making sure no cables are pinched. Cable the peripherals to the panel connectors, reconnect the system to the AC or DC power source, and turn the equipment power on. Note Not all peripheral cables are provided with the MVME712M; you may need to fabricate or purchase certain cables. (To minimize radiation, Motorola recommends shielded cable for peripheral connections where possible.)

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.

 Superior products

We mainly make spare parts for DCS, PLC, robot control system and large servo system.

Main products: various modules/cards, controllers, touch screens, servo drives.

Advantages: professional off production accessories,

Fast delivery, accurate delivery time,

Main brands include ABB, GE/FANC, FOXBORO, TRICONEX, BENTLY NEVADA, A-B, EMERSON, OVATION, MOTOROLA, XYVOM, HONEYWELL, REXROTH, KUKA, NI, DEIF, Reliance Electric, Yokogawa, WOODWARD, SCHNEIDER, MOOG, PROSOFT and other brands