HIMA Z6013 Adjustment control card

This section applies to MVME761-compatible models of the MVME2603/2604 VME module. With the MVME2603/2604 installed, refer to Figure 1-22 and proceed as follows to install an MVME761 transition module: 1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure. 2. Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME modules.

The MVME2600, MVME761-compatible models will be damaged if mistakenly connected to the MVME712 family of boards instead of the correct MVME761 transition modules.

Inserting or removing modules

 with power applied may result in damage to module components. ! Warning Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing, and adjusting. 3. Remove the filler panel(s) from the appropriate card slot(s) at the front or rear of the chassis. (You may need to shift other modules in the chassis to allow space for the cabling to the MVME761.)Route the 64-conductor cable furnished with the MVME761 from J3 on the P2 adapter board to P2 on the transition module. Be sure to orient cable pin 1 with connector pin 1. ! Caution Avoid touching areas of integrated circuitry; static discharge can damage these Secure the MVME761 in the chassis with the screws provided, making good contact with the transverse mounting rails to minimize RF emissions.

The cabling can be configured 

in a number of ways to accommodate various device and system configurations. Figure 1-22 shows one possible configuration. For more detailed information on installing the P2 adapter board and the MVME761 transition module, refer to the user’s manual (listed in Appendix D, Related Documentation). 7. Replace the chassis or system cover(s), making sure no cables are pinched. Cable the peripherals to the panel connectors, reconnect the system to the AC or DC power source, and turn the equipment power on. Note Not all peripheral cables are provided with the MVME761; you may need to fabricate or purchase certain cables. (To minimize radiation, Motorola recommends shielded cable for peripheral connections where possible.)

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.

 Superior products

We mainly make spare parts for DCS, PLC, robot control system and large servo system.

Main products: various modules/cards, controllers, touch screens, servo drives.

Advantages: professional off production accessories,

Fast delivery, accurate delivery time,

Main brands include ABB, GE/FANC, FOXBORO, TRICONEX, BENTLY NEVADA, A-B, EMERSON, OVATION, MOTOROLA, XYVOM, HONEYWELL, REXROTH, KUKA, NI, DEIF, Reliance Electric, Yokogawa, WOODWARD, SCHNEIDER, MOOG, PROSOFT and other brands