ABB PFCL301E 0.2kN 3BSE016580R1000 Tension sensor

Always make sure that the motors are de-energized during assembly and wiring, i.e. No voltage may be switched on for any piece of equipment which is to be connected. Ensure that the switch cabinet remains turned off (barrier, warning signs etc.). The individual voltages will only be turned on again during commissioning The ground symbol, which you will find in the wiring diagrams, indicates that you must provide an electrical connection, with as large a surface area as possible, between the unit indicated and the mounting plate in the switch cabinet. This connection is to suppress HF interference and must not be confused with the PE (protective earth) symbol (protective measure to EN 60204). To wire up the motor, use the wiring diagrams in the Installation and Commissioning Instructions of the servo amplifier which is used.

The following notes should help you to carry out the assembly

wiring in an appropriate sequence, without overlooking anything. The site must be free of conductive and aggressive material. For V3-mounting (shaft end upwards), make sure that no liquids can enter the bearings. If an encapsulated assembly is required, please consult our applications department beforehand. Ensure an unhindered ventilation of the motors and observe the permissible ambient and flange temperatures. For ambient temperatures above 40°C please consult our applications department beforehand.

Select cables according to EN 60204 

See the table in chapter II.1 when cable length exceeds 25m. Use correct earthing and EMC-shielding according to the Installation Instructions for the servo amplifier which is used. Earth the mounting plate and motor casing. For connection methods see chapter II.2.1 — Route power cables as separately as possible from control cables — Connect up the resolver — Connect the motor leads, install ring cores or motor chokes close to — the servo amplifier, connect shields to shielding terminals or EMC — connectors at both ends — Connect the holding brake, if used, Connect shielding at both ends

Our products

A company specializes in the sales of module spare parts of global famous brands (DCS system) (robot system) (large servo control system). The company's products include distributed control system (DCS), programmable controller (PLC), MOTOROLA MVME industrial module, industrial control communication converter (Anybus), remote output/input module (RTU), industrial computer (IPC), industrial low screen screen (IPC) HMI SCSI (50, 68, 80Pin) AnyBus (Gateway) has become a global sales enterprise of industrial automation spare parts and components

Payment method and delivery

Shipment: EMS,DHL,UPS & FEDEX

Payment: T/T or Western Union