ABB SA801F 3BDH000011R1 Axial displacement module

The IDE interface is available to connect up to two IDE devices, such as hard disks, CD-ROM drives or CompactFlash. Connector J5 is the primary IDE controller with a 44-pin 2 mm connector. Use the CMOS setup to specify the drive parameters of the drive. If you use the onboard CompactFlash device, only one other IDE device can be connected to the IDE controller. Cable length must be 18" or less to maintain proper signal integrity. This interface supplies power to 2.5" IDE drives. If you are connecting a 3.5" drive to the interface (using the CBL/CBR-4405 44-pin to 40-pin IDE adapter), you must supply external power to the drive. The power cable attached to a 3.5" drive must be properly grounded so that motor current is not returned via the grounds in the data cable.

Keyboard and Mouse 

A standard PS/2 keyboard and mouse interface is accessible through connector J12.The 5V power provided to the keyboard and mouse is protected by a 1 Amp fuse. This connector uses IEC 61000-4-2-rated TVS components to help protect against ESD damage.D4 includes an output signal for attaching a software controlled LED. An on-board resistor limits the current to 15 mA when the circuit is turned on. To turn the LED on and off, set or clear bit D7 in I/O port 1D0h. When changing the register, make sure not to alter the value of the other bits.

Note: The LED is turned on by the BIOS during system startup. This causes the light to function as a "power on" indicator if it is not otherwise controlled by user code. The BIOS also flashes the LED in sync with “Beep Codes” when an error occurs.

Push-Button Reset

 Connector J9 includes an input for a push-button reset switch. Shorting J9, pin 25 to ground causes the EPIC-2 to reboot. This connector uses IEC 61000-4-2-rated TVS components to help protect against ESD damage. IDE LED D4 outputs signal for IDE Activity LED. An on-board resistor limits the current to 15 mA when the circuit is turned on. D4 top LED is for IDE, D4 bottom LED is for the programmable LED.

Application industry

The products can be used in the following industries: power plant, paper making, steel, mining, rubber, water supply, cement, chemical industry, glass, printing

Textile, machinery, plastics, coatings, medicine, hospitals, food, hotels, scientific research institutions

Do you want to know about our products?

We have a large amount of inventory and high quality, out of production control system components, DCS system accessories, robot system accessories, large servo system spare parts. PLC module, DCS module, CPU module, IO module, DO module, AI module, DI module, network communication module, Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output module, redundancy module, power module, relay output module, relay input module, processor module and other major brands.