ABB 3HNA000512-001 Analog input module

The safe operating ambient temperature range for the GHW-25 / GHW-50 Genesis generator is a minimum of 10°C and maximum of 40°C. The generator requires water to cool the high temperatures that are built up in the unit during operation. The recommended flow of water into and out of the generator is a minimum of 2.0 gallons (7.6 liters) per minute at a maximum pressure of 60 psi. The temperature of the cooling water must be between +5°C and +35°C. The water inlet and outlet fittings are 3/8” female NPT pipe on the rear panel and have been designed to accept 3/8” male (NPT) pipe thread.

Cooling Water Requirements

If conditions exist where the water coolant temperature is below the ambient dew point temperature, ENI recommends that either 1.) in-line solenoid valves be installed on the water connections to the generator and be closed when generator RF power is off or 2.) coolant water temperature be adjusted to prevent condensation. Follow this recommendation to prevent condensation from forming when the generator is off; failure to do so may result in extensive damage to the generator! Contact ENI Service for more information.

Water Fittings Connection 

Leak-free water connections are necessary for generator reliability. To ensure this, the following procedure must be followed for all ¼-inch NPT pipe fittings. The materials and parts needed for this procedure are: • Teflon tape, 0.5 in. (ENI P/N: 521257) • Torque wrench as specified below. 1. Check fittings’ and water ports’ pipe threads for metal splinters, signs of cross threading (e.g., channel cut across the threads), impact damage, or signs of excessive wear. Repair or replace parts as necessary. Remove all pieces of used Teflon pipe tape.

Company introduction

Temporal Ming sheng automation equipment co., LTD. Was established in April 02, 2021, registered jiujiang ruichang city in jiangxi province, east yi road no. 23 lake farmers 401 mall, the legal representative person Zhou Zuochen.

[Main Products]

Main products: PLC and DCS system spare parts modules of world famous brands

①Allen-Bradley 1756、1746、1747、1771、1785

②Schneider 140 Series PLC module

③General electric GE

IC693 IC697 IC698 Series PLC module

DS200 DS3800 DS215 IS200 IS215 IS220 Series gas turbine module

VMIVME Control module of series

④Bently：3500 series cards 3500/22M、3500/15、3500/92 And other products

⑤ICS TRIPLEX

⑥ABB Robots. FANUC Robots、YASKAWA Robots、KUKA Robots、Mitsubishi Robots、OTC Robots、Panasonic Robots、MOTOMAN Robots。

⑦EMERSON：Spare parts for OVATION system, WDPF system and MAX1000 system.

⑧ Invensys Foxboro: I/A Series system, FBM (field input/output module) sequential control, ladder logic control, accident recall processing, digital analog conversion, input/output signal processing, data communication and processing, etc. Invensys Triconex: redundant fault-tolerant control system, Zui modern fault-tolerant controller based on triple module redundancy (TMR) structure.

⑨Woodward：505 series governor 9907-164 And other products

⑩Bosch Rexroth：Indramat，I/O module,PLC CPU,Motors, drives and other products. 

◆Motorola：MVME 162、MVME 167、MVME1772、MVME177and other products.