ABB 3HNE00313-1 Prog.Unit

The AC line cord is plugged into the AC Input receptacle on the rear panel. Make sure it is 208VAC, 3 phase. (See section 2.9 for more information on AC Power Requirements.) 5. The RS-232 serial cable is connected to the 9-pin D-type serial connector on the rear panel. 6. The Analog Interface is connected to the 25-pin D-type analog I/O connector on the rear panel. (See section 2.4 for more information on the types of analog interfaces available.) This may vary depending upon the type of analog interface that was ordered (See section 1.4.1 for the different types of analog interfaces). 7. The RF output cable is connected to the RF Output connector on the rear panel. 8. The RF output cover is on, defeating the RF interlock. AC Power will not engage until this interlock is defeated (plugged).

Initial Power Up 

Flip the AC mains switch up to the ON position (The I symbol should be showing). You should hear the contactor engage. The front panel display should appear like the following Simple operation been designed into the GHW-25 / GHW-50 Genesis generator to accommodate various plasma applications. User input has been simplified to require just a few parameters such as a fixed frequency and a set number of watts.

The GHW-25 / GHW-50 Genesis generator is designed to be used with minimal input from the user.

Turning on AC Mains Power 

Before operation of the front panel begins make sure the system check has been performed in Section 2.12. After that has been done, the generator should be turned on. To do this, follow the procedure below: 1. Flip the AC mains switch up to the ON position (The I symbol should be showing). You should hear the contactor engage. The front panel display should appear like the following:The LOCK button prevents all front panel controls (except the Lock button itself) from working. This provides protection against inadvertent movement of the rotary knob. A LED inside the button is turned on to indicate that the lock function is active. The LOCK condition, when active, locks out the entire front panel (except for the LOCK button itself).

Company introduction

Temporal Ming sheng automation equipment co., LTD. Was established in April 02, 2021, registered jiujiang ruichang city in jiangxi province, east yi road no. 23 lake farmers 401 mall, the legal representative person Zhou Zuochen.

[Main Products]

Main products: PLC and DCS system spare parts modules of world famous brands

①Allen-Bradley 1756、1746、1747、1771、1785

②Schneider 140 Series PLC module

③General electric GE

IC693 IC697 IC698 Series PLC module

DS200 DS3800 DS215 IS200 IS215 IS220 Series gas turbine module

VMIVME Control module of series

④Bently：3500 series cards 3500/22M、3500/15、3500/92 And other products

⑤ICS TRIPLEX

⑥ABB Robots. FANUC Robots、YASKAWA Robots、KUKA Robots、Mitsubishi Robots、OTC Robots、Panasonic Robots、MOTOMAN Robots。

⑦EMERSON：Spare parts for OVATION system, WDPF system and MAX1000 system.

⑧ Invensys Foxboro: I/A Series system, FBM (field input/output module) sequential control, ladder logic control, accident recall processing, digital analog conversion, input/output signal processing, data communication and processing, etc. Invensys Triconex: redundant fault-tolerant control system, Zui modern fault-tolerant controller based on triple module redundancy (TMR) structure.

⑨Woodward：505 series governor 9907-164 And other products

⑩Bosch Rexroth：Indramat，I/O module,PLC CPU,Motors, drives and other products. 

◆Motorola：MVME 162、MVME 167、MVME1772、MVME177and other products.