Setting the RF power Next the amount of power in watts has to be set and RF power has to be requested. To request RF power, do the following:1. Press the ON/OFF button first to enable and disable the RF power output. The RF ON LED will illuminate (located to the right of the digitizer knob and to the left of the circuit breaker).2. Use the digitizer knob to set the amount of power in watts from 10W to 2500W. Watch the display until the desired wattage appears on the second line above the set point field.If this is not a variable frequency unit, “NORMAL” will be displayed in the STATUS field rather than a frequency.
Entering the frequency menu
The first step in setting up the frequency menu is entering the menu(s) from the front panel. This is done by the following steps: 1. This is the normal display on the generator.If this is not a variable frequency unit, “NORMAL” will be displayed in the STATUS field rather than a frequency.
To change the RF output frequency, press the MENU button again until the "TUNE MODE>" field appears. Use the Item Up button to change the valve from "AUTO" to "MAN."Press the MENU button until the "FREQ> XXXX" (XXXX is the frequency the generator is currently registering) field appears. The frequency can now be adjusted using the digitizer knob.
If the configuration of the generator is fixed-frequency
you will not be able to change the frequency value. If it is not, then use the digitizer knob to change the frequency. However, if the unit is a variable frequency unit, it will be in the auto-tune mode and will have already tuned to the best frequency. Check the serial number of your unit and refer to the Part Number Interpreter to determine if your unit has the Auto-Tune option. Auto-Tune Mode This software option enables the generator to vary its operating frequency to achieve the lowest possible reflected power for a given load condition.
Company introduction
Temporal Ming sheng automation equipment co., LTD. Was established in April 02, 2021, registered jiujiang ruichang city in jiangxi province, east yi road no. 23 lake farmers 401 mall, the legal representative person Zhou Zuochen.
[Main Products]
Main products: PLC and DCS system spare parts modules of world famous brands
①Allen-Bradley 1756、1746、1747、1771、1785
②Schneider 140 Series PLC module
③General electric GE
IC693 IC697 IC698 Series PLC module
DS200 DS3800 DS215 IS200 IS215 IS220 Series gas turbine module
VMIVME Control module of series
④Bently:3500 series cards 3500/22M、3500/15、3500/92 And other products
⑤ICS TRIPLEX
⑥ABB Robots. FANUC Robots、YASKAWA Robots、KUKA Robots、Mitsubishi Robots、OTC Robots、Panasonic Robots、MOTOMAN Robots。
⑦EMERSON:Spare parts for OVATION system, WDPF system and MAX1000 system.
⑧ Invensys Foxboro: I/A Series system, FBM (field input/output module) sequential control, ladder logic control, accident recall processing, digital analog conversion, input/output signal processing, data communication and processing, etc. Invensys Triconex: redundant fault-tolerant control system, Zui modern fault-tolerant controller based on triple module redundancy (TMR) structure.
⑨Woodward:505 series governor 9907-164 And other products
⑩Bosch Rexroth:Indramat,I/O module,PLC CPU,Motors, drives and other products.
◆Motorola:MVME 162、MVME 167、MVME1772、MVME177and other products.