YASKAWA YPHS31008-1D Voltage module

• The connecting leads should be suitable for the type of use, as well as the voltages and amperages concerned. 

• The protective earth must be connected to the terminal marked PE. 

• All cables used should be provided with a shield and in addition, the encoder cable should feature twisted pair leads. 

• The power supply is switched off before connecting and disconnecting the power connection and signal connections

Encoders and sensors contain electrostatically sensitive components, observe the ESD measures!Check the direction of rotation of the load uncoupled. In the event of changes in the normal operating behaviour, such as increased temperature, noise or vibration, switch the actuator off. Determine the cause of the problem and contact the manufacturer if necessary. Even if the actuator is only on test, do not put safety equipment out of operation. This list may not be complete. Other checks may also be necessary

Before commissioning, please check that:

 • The actuator is properly mounted, 

• All electrical connections and mechanical connections are designed according to requirements, 

• The protective earth is properly connected, 

• All attachments (brakes, etc) are operational, 

• Appropriate measures have been taken to prevent contact with moving and live parts, 

• The maximum speed nmax is specified and cannot be exceeded, 

• The set up of the drive parameters has been executed, 

• The commutation is adjusted correctly.

Overload Protection 

Temperature sensors are integrated into the servo actuators and motors to protect them from. To protect the servo actuators and motors from temperature overload sensors are integrated into the motor windings. The temperature sensors alone do not guarantee motor protection. Protection against overload of the motor winding is only possible only with an input speed > 0. For special applications (eg load at standstill or very low speed) is an additional overload protection by limiting the overload period. The built specification of the integrated temperature sensors can be found in the technical data.

Company introduction

Temporal Ming sheng automation equipment co., LTD. Was established in April 02, 2021, registered jiujiang ruichang city in jiangxi province, east yi road no. 23 lake farmers 401 mall, the legal representative person Zhou Zuochen.

[Main Products]

Main products: PLC and DCS system spare parts modules of world famous brands

①Allen-Bradley 1756、1746、1747、1771、1785

②Schneider 140 Series PLC module

③General electric GE

IC693 IC697 IC698 Series PLC module

DS200 DS3800 DS215 IS200 IS215 IS220 Series gas turbine module

VMIVME Control module of series

④Bently：3500 series cards 3500/22M、3500/15、3500/92 And other products

⑤ICS TRIPLEX

⑥ABB Robots. FANUC Robots、YASKAWA Robots、KUKA Robots、Mitsubishi Robots、OTC Robots、Panasonic Robots、MOTOMAN Robots。

⑦EMERSON：Spare parts for OVATION system, WDPF system and MAX1000 system.

⑧ Invensys Foxboro: I/A Series system, FBM (field input/output module) sequential control, ladder logic control, accident recall processing, digital analog conversion, input/output signal processing, data communication and processing, etc. Invensys Triconex: redundant fault-tolerant control system, Zui modern fault-tolerant controller based on triple module redundancy (TMR) structure.

⑨Woodward：505 series governor 9907-164 And other products

⑩Bosch Rexroth：Indramat，I/O module,PLC CPU,Motors, drives and other products. 

◆Motorola：MVME 162、MVME 167、MVME1772、MVME177and other products.