The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

SR469-P5-HI-A20-E relay

MOTIONLINK requires an IBM-PC or compatible computer with the following features: ♦ IBM-compatible, Pentium or higher computer. ♦ 16 M RAM. ♦ Windows 95, Windows98, WindowsNT 4.0 with Service Pack 3, Windows 2000. ♦ CD-ROM player. ♦ Standard Video Adapter (CGA, MDA, EGA, MCGA, VGA, or SVGA). ♦ Serial Port (for communication link with SERVOSTAR CD-Lite). The serial communications port may be COM1, COM2, COM3, or COM4. COM1 is the normal configuration: COM1: Address 3F8h, Interrupt Request #4

The following chart shows the flow of data between the PC and the SERVOSTAR CD-Lite. When logic power is applied to the drive, it loads the variable parameters stored in EEPROM into the dynamic RAM for fast and easy access. You can read (and write) these variable parameters to (and from) the PC by one of several methods described in the INITIAL STARTUP section below.The PC transmits serial data to the drive and stores it in dynamic RAM. However, any variable data changed from the PC is lost when logic power is lost, if it is not saved into non-volatile EEPROM. If you configure the same system on similar applications, the variables can be saved on disk in an .SSV file for convenient downloading into other drives.

Installing MOTIONLINK

 ♦ Insert the CD-ROM to load MOTIONLINK for Windows. ♦ The CD-ROM should AUTORUN. If not, select Start | Run (or browse your CD-ROM drive). ♦ Type “D:AUTORUN.EXE” and press the Enter key (this assumes your CD player has a D: letter designation). ♦ Select a product and follow the instructions on the screen. To run the program, go to your Start/Programs listing and select SERVOSTAR MOTIONLINK from the menu (or click on the SERVOSTAR MOTIONLINK icon if loaded on the desktop). Using MOTIONLINK MOTIONLINK gives you three methods to configure the drive. The first uses a Startup Wizard and is the easiest and most highly recommended approach. Its main purpose is for initial startups. The second approach allows you to more indirectly perform the same configuration as the first using the Main MOTIONLINK screen. This method is most convenient when corrections to an existing configuration are required. The third method uses the Terminal Mode screen to directly set (or monitor) values for the same variables and commands that the other two methods configure through a more friendly user interface. You can gain a more thorough understanding of the SERVOSTAR drive, MOTIONLINK, and its variable and command set by using the context-sensitive Help (F1) provided in MOTIONLINK. When you begin, the first screen you see is: Startup Wizard This screen appears the first time (and any time after should you choice not to deselect it) MOTIONLINK is run on a PC. It is designed to guide you through a step-by-step approach to configure a drive. Click the “START” button on the first user screen and walk through the complete sequence of buttons provided to set the drive, motor, and application (Opmode, Tune, Backup, Go) variable parameters.