ABB P37131-4-0369632 Processor module

THE PRINCIPLE OF PROGRAMMING Programming of the alarm panel is carried out by means of the 3 push-buttons CHANNEL SELECT, FUNCTION SELECT and ENTER, positioned at the lower right corner of the front plate. The principle of programming is as follows: "Point" to the requested channel (by means of CHANNEL SELECT); then "point" to the requested function (by means of FUNCTION SELECT); finally select, i.e. enter, the requested function (by means of ENTER).

The LEDs will, as described in the following

 indicate which channel/function is being programmed at the moment. The channels/functions are shown in a certain order. The CHANNEL SELECTOR first points to channel 1, repeated pressing of the pushbutton enables stepping through the channels 1-2-3-4-5-6-7-8-1-2-3, etc. Likewise you step through the various functions. The order of these appears from the following pages of this manual.

The individual functions are as follows: 

1) Registration of alarm on open or closed signal contact - i.e. selection between N/C or N/O. 

2) Activation of output(s) A and/or B on an alarm condition - "OUTPUT A", "OUTPUT B" 

3) Inhibit of incoming alarms - "INHIBIT" 

4) Detection and indication of cable failure - "CABLE FAILURE" 

5) Time delayed registration of an alarm condition. The time delay "DELAY OF ALARM" can be set within the range 0..40 secs at intervals of 1 sec.

                                                                        

Application industry

The products can be used in the following industries: power plant, paper making, steel, mining, rubber, water supply, cement, chemical industry, glass, printing

Textile, machinery, plastics, coatings, medicine, hospitals, food, hotels, scientific research institutions

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/