ABB 83SR04E-E GJR2390200R1210 Pulse input module

The equipment is not intended for continuous exposure to direct sunlight This might accelerate the aging process of the front panel film. The equipment is not intended for installation in contact with corrosive chemical compounds. Check the resistance of the front panel film to a specific compound before installation. Do not use tools of any kind (screwdrivers, etc.) to operate the keyboard of the panel or the touch screen.

In order to meet the front panel protection classifications

proper installation procedure must be followed: • the borders of the cutout must be flat 

• screw up each fixing screw until the plastic bezel corner get in contact with the panel. 

• The cutout for the panel must be of the dimensions indicated in this manual. 

• Two types of gaskes are delivered with the UniOP panels, depending on the model, rectangular or linear. Applying the rectangular gasket 

• The gasket should be applied around the cutout prepared for the panel being careful not to place it under tension 

• The gasket should be replaced every time that the panel is dismounted and remounted in its place

Applying the two linear gaskets:

 Thin strip: • The gasket should be applied around the cutout prepared for the panel 

• The gasket should be applied starting from the middle of the lower side being careful not to place it under tension 

• The two ends of the gasket should meet without overlap 

• The gasket should be replaced every time that the panel is dismounted and remounted in its place

                                                                        

Professional seller

Professional sales of major electrical brand products in the world

Overseas direct purchase of products, authentic inventory, price concessions

After sales warranty, complete models, same products, different prices and services

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/