Large strip: • The gasket should be applied on the operator panel just behind the bezel
• The gasket should be applied starting from the 1/3 of the lower side being careful not to place it under tension
• The two ends of the gasket should meet without overlap
• The gasket should be replaced every time that the panel is dismounted and remounted in its place
Installation Procedures
Place the four fixing brackets on the longer side near the corners, as shown in figure (Figure 48). Screw each fixing screw until the plastic or aluminium bezel corner get in contact with the panel.The equipment must be cleaned only with a soft cloth and neutral soap product. Do not use solvents. Handling the Memory Cards The SSFDC memory cards used in some of the UniOP operator panels need to be handled with care when replaced in the memory slot of the panel.
Before inserting the memory card in its slot in the panel
the contact area must be verified to be clean. Any track of contaminants such as oil or any greasy substances should be carefully removed. Contamination on the golden contacts of the memory card, at the moment the media is inserted in the slot, may generate an insulating layer that may result in electrical contact problems with the sliding elements of the socket. Corrosive / active chemicals may permanently damage the memory card golden surface. Any contact with such substances must be carefully avoided. To ensure the proper operation of the memory media the contact surface of the SSFDC card should be cleaned with a soft, clean tissue.
Professional sales of major electrical brand products in the world
Overseas direct purchase of products, authentic inventory, price concessions
After sales warranty, complete models, same products, different prices and services
This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/