The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

BENTLY 3500/32 125712-01 Relay module

The set address is read in once after the supply voltage was applied. A change of address is therefore only valid after a power-on reset of the card. When assigning the addresses, take in any case care that a clear and unique address is assigned to each Profibus station. For further information on the handling of Profibus parameters, please refer to the documentation “RE 30028-01-Z“.

Transport and store the control electronics VT-VPCD in the antistatic packaging, in which it is delivered. Observe the notes on top of the packaging as well as the notes in Chapter 2 ”Safety instructions“. In any case, when storing and transporting the electronics, adhere to the ambient conditions given in the technical data in the data sheet. 6.1 Storing the VT-VPCD To prepare the control electronics for storage and further use, proceed as follows: ▶ Only use the original packaging for storing. ▶ Observe the permitted storage temperature range of -20 °C to +70 °C. ▶ Protect the VT-VPCD against dust and humidity.Fault currents and short-circuits! Impaired safety and malfunction. ▶ The surroundings must be free from conductive contamination (acids, lyes, corrosive agents, salts, metal vapors, etc.), and the device must not be exposed to them. Generally, rule out deposits according to protection class IP 65. Cables lying around! Risk of stumbling. ▶ Route cables and lines so that they cannot be damaged and nobody can stumble over them.

Great differences in potential! 

Risk of destruction of the control electronics VT-VPCD by plugging in or removing the electronics while connected to the power supply. ▶ Disconnect the relevant system part from the power supply before you plug, remove or connect the electronics. Damage to the electronics caused by incorrect installation is not covered by the warranty! ▶ Observe the protection class, the voltage supply and ambient conditions as specified in data sheet RE 30028. Electrostatic discharge! Risk of destruction of the control electronics VT-VPCD. ▶ Keep the control electronics in the antistatic packaging until it is installed and observe the notes on top of the packaging when unpacking the electronics. Radiated interference! Risk of malfunction. ▶ Keep a sufficient distance to radio equipment (>> 1 m). ▶ Do not install solenoid and signal cables near power cables. ▶ Shield command and actual value cables. Leave the shield open at one end and connect it to system ground on the card side.

Unpacking ▶ Only remove the card at a protected workplace. ▶ Handle the control electronics at the front panel and do not touch any electrical components.