Home > Product > PLC programmable module > MOTOROLA MVME162-413 Channel output module

MOTOROLA MVME162-413 Channel output module

Press both the Target Flame Select and Background Flame Select buttons simultaneously. Use the up button to drive the LEDs until LED number [5] (pass code) is illuminated (if you pass the required point use the down button to correct). Press both the Target Flame Select and Background Flame Select buttons simultaneously.

Press the Target Flame select button (the Learn Target Flame LED illuminates).

Note also that the flame relay output is energized when the Target Flame Select button is depressed. This is to allow the Phoenix Scanner to signal flame present to the BMS during commissioning Flame must be present during scanner setup. Verify flame condition prior to depressing the Target Flame select button and energizing the flame relay output. During the setup process, run the flame at the lowest acceptable setting for flame on condition, e.g. low fire or pilot if the scanner is required to detect the condition. The scanner is at maximum gain during this mode. Note: There is a time limit function associated with manual use of the flame relay output. If this time period of two minutes is exceeded, repeat from step one.