GE DS200TCDAH1BGD Channel temperature module
500 ohm Load Waveform Capture a. Configure the test fixture board, resistor, and transducer for the 500 ohm load waveform measurement as described in Section 5.2.2.2. b. Record waveforms at 1000 and 4000 volts, both positive and negative polarities. Verify that the waveforms meet all parameters specified in Figure 3 and Table 1.
Spurious Current Pulse Detection
Secondary pulses after the HBM pulses are generated by the discharge relay. Using the shorting wire configuration, initiate a 1000 volt pulse and verify that any pulses after the initial HBM pulse are less than 15% of the amplitude of the main pulse. NOTE: For analog oscilloscopes, setting the time base to 1 millisecond/division can detect these types of pulses. For digital oscilloscopes, current pulses after the initial current pulse can be observed, but advanced triggering functions such as sequential triggering or delayed triggering may be needed so secondary pulses are not missed due to low sampling rates.
A company specializes in the sales of module spare parts of global famous brands (DCS system) (robot system) (large servo control system). The company's products include distributed control system (DCS), programmable controller (PLC), MOTOROLA MVME industrial module, industrial control communication converter (Anybus), remote output/input module (RTU), industrial computer (IPC), industrial low screen screen (IPC) HMI SCSI (50, 68, 80Pin) AnyBus (Gateway) has become a global sales enterprise of industrial automation spare parts and components
This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/