GE DS200TCEAG1BRE Cylinder pressure monitor

Test Fixture Board Qualification Test fixture boards shall be qualified in a qualified tester prior to initial use or after repair. This procedure is also required when a previously qualified test fixture board is used in a different model HBM simulator from the one in which it was originally qualified. The procedure shall be applied to the reference pin pairs on all sockets of the new test fixture board. If there is not adequate physical access to the socket, follow the guidance of Section 5.2.2.1b.

Standard Routine Waveform Check Description 

Waveforms shall be acquired using the short circuit method (Section 5.2.2.1) on the reference pin pair for each socket. If necessary, the test fixture board being used may be removed and replaced with a positive clamp socket test fixture board to facilitate waveform measurements. Stresses shall be applied at positive and negative 1000 volts or the stress level to be tested during the use. The waveforms shall meet the requirements of Figures 2A and 2B and Table 1.

Our products

A company specializes in the sales of module spare parts of global famous brands (DCS system) (robot system) (large servo control system). The company's products include distributed control system (DCS), programmable controller (PLC), MOTOROLA MVME industrial module, industrial control communication converter (Anybus), remote output/input module (RTU), industrial computer (IPC), industrial low screen screen (IPC) HMI SCSI (50, 68, 80Pin) AnyBus (Gateway) has become a global sales enterprise of industrial automation spare parts and components

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/