GE DS2020LCCBE7L06P44N4 Dynamic pressure monitor

For a switch that comes with a DC terminal block, perform the following steps: 1. Before attaching wires to the DC terminal block at the rear of the switch, review the following warning: Warning As a safety precaution, a 10 Amp circuit breaker should be installed at the supply end of the cable to be used with this LAN equipment. ALWAYS connect the wiring to the LAN equipment first before connecting the wiring to the breaker. To avoid the danger of physical injury from electrical shock, do not work with HOT feeds. Always be sure that the breaker is in the OFF position before connecting the wiring to the breaker. 16

A tray cable is required to connect the power source

if the unit is powered by centralized DC power. The tray cable must be UL listed Type TC tray cable and rated at 600 V and 90 degree C, with three conductors, minimum 14 AWG. 2. On the rear side of the chassis is a DC terminal block. Starting from the left side of the terminal block, identify the positive, frame ground, and negative terminals using either the diagram adjacent to the terminal block or the illustration here

Do you want to know about our products?

We have a large amount of inventory and high quality, out of production control system components, DCS system accessories, robot system accessories, large servo system spare parts. PLC module, DCS module, CPU module, IO module, DO module, AI module, DI module, network communication module, Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output module, redundancy module, power module, relay output module, relay input module, processor module and other major brands.

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/