GE DS202PMAG4 Line interface module

Plug the AC/DC power adapter into an appropriate AC power outlet and insert the power plug into the DC receptacle located on the back of the unit. Refer to Figure 7. This step does not apply if you installed the unit in an AT-MCR12 chassis.Verify that the PWR LED is green. If the LED is OFF, refer to “Troubleshooting” on page 17 for instructions.Remove the dust cover from the fiber optic connector and connect the cable to the fiber optic port. Verify that the media converter’s transmitter port (TX) is connected to the end-node’s receiver port (RX) and that the media converter’s receiver port (RX) is connected to the end-node’s transmitter port (TX).

Connect the twisted pair cable to the twisted pair port.

Set the MDI/MDI-X switch as follows: — If you are connecting a workstation to the 10Base-T/100Base-TX port, set the MDI/MDI-X switch to the MDI-X position. (MDI-X is the default.) — If you are connecting a hub or switch to the 10Base-T/100Base-TX port, set the MDI/MDI-X switch to the MDI position. 10. Power on the end-nodes. 11. Depending on your configuration, check that the 10 or 100 LED for both ports on the media converter are green. If the LEDs are OFF, refer to “Troubleshooting” on page 17. The media converter is now ready for use.

Do you want to know about our products?

We have a large amount of inventory and high quality, out of production control system components, DCS system accessories, robot system accessories, large servo system spare parts. PLC module, DCS module, CPU module, IO module, DO module, AI module, DI module, network communication module, Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output module, redundancy module, power module, relay output module, relay input module, processor module and other major brands.

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/