The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on.

ORIENTAL MOTOR 2GK180K Industrial camera

almost seamlessly if bypass power falls outside the user-set limits. Once bypass power returns within the acceptable parameters, the UPS will return to Active ECO Mode operation. The default setting is Active ECO Mode Off.Do NOT attempt to start the UPS, turn on any circuit breaker or energize the input power until instructed to do so in Starting the UPS on page 35. 3.1 What’s Included • Terminal Block Communication Terminals • Compact Disk with: • Liebert MultiLink® Shutdown Software • Configuration Program • User Manual (electronic version) • USB Cable—one, 2 m (6-1/2 ft) long • Rack mounting hardware, including screws, mounting rail kit (mounting rail kit not included with “E” models) • Two plastic, tower-stand support-base sets (four pieces) • Warnings, Safety Instructions booklet and WEEE recycling sheet (ISO 14001 compliance) With 700VA – 1500VA Units: • 10A IEC C13 C14 Output Cable—two, 2 m (6-1/2 ft) long • CEE 7/7 (Schuko) to IEC C13 input cord—one, 2.5 m (8-1/2 ft) long • BS 1363 (UK) to IEC C13 input cord—one, 2.5 m (8-1/2 ft) long • Australian type A to SAA input cord—one (not included with “E” models) With 2000VA – 3000VA Units: • 10A IEC C13 C14 Output Cable—three, 2 m (6-1/2 ft) long • CEE 7/7 (Schuko) to IEC C20 Input Cable—one, 2.5 m (8-1/2 ft) long • BS1363 (UK) to IEC C20 Input Cable—one, 2.5 m (8-1/2 ft) long • Australian type A to SAA input cord—one (not included with “E” models) NOTE: The GXT4 External Battery Cabinet shipping package includes one battery cabinet, two spacers for tower configuration and one DC-power cable and rack-mounting hardware, including screws, handles and mounting rail kit (not included with “E” models).

Unpacking and Inspection 

Unpack the UPS and conduct the following checks: • Inspect the UPS for shipping damage. If any shipping damage is found, report it to the carrier and your local dealer or your Vertiv™ representative immediately. • Check the accessories included in packaging list. If there is any discrepancy, contact your local dealer or your Vertiv™ representative immediately.Preparation for Installation 3.3.1 Installation Environment • Install the UPS indoors in a controlled environment, where it cannot be accidentally turned Off. The installation environment should meet the specifications listed in Specifications on page 53. • Place it in an area of unrestricted air-flow around the unit, away from water, flammable liquids, gases, corrosives, and conductive contaminants. Avoid direct sunlight. NOTE: Operating the UPS in temperatures above 77°F (25°C) reduces battery life. 3.3.2 Installation Clearances Maintain at least 4 in. (100 mm) clearance in the front and rear of the GXT4. Do not obstruct the air inlets on the front panel and rear panel of the UPS. Blocking the air inlets reduces ventilation and heat dissipation, shortening the service life of the Liebert GXT4.