GEC ALSTHOM MVAJ53H1LB0856A Voltage monitoring module

Program the supply to full-scale current. When the output current is at full-scale ± 0.1 %, send the command : "TRCG". This will store the current read gain value in the EEPROM for later use in readback calculations. Send command "MC" to initiate a read of the current channel. Check to make sure the reading is now correct. Program and measure the current for several points throughout the supply's range. The programming and readback should track closely.

DEMONSTRATION GWBASIC PROGRAM 

The following is a GWBASIC program to operate the RSTL controller card. This program requires the use of a National Instruments GPIB interface card in an AT-type PC. In addition, the Universal Language Interface program (ULI - included with National Card) should be run prior to running this GWBASIC program. See the National Instruments manual for proper installation and setup of the IEEE-488 Interface Card. Line 2000 is the serial poll wait routine. After a command is sent the program looks for b4 to be set in the serial poll output register.

Do you want to know about our products?

We have a large amount of inventory and high quality, out of production control system components, DCS system accessories, robot system accessories, large servo system spare parts. PLC module, DCS module, CPU module, IO module, DO module, AI module, DI module, network communication module, Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output module, redundancy module, power module, relay output module, relay input module, processor module and other major brands.

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/