The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on.

KOLLMORGEN 60WKS-CE240/22PB Driver module

To cancel the connection from the client, you only have to close the main screen. Before the application is shut down, it transmits some commands to the server to enable the server to detect the termination of the connection more quickly. If the connection is canceled from the server, or is interrupted as a result of a connection termination, an error message is issued and the application is then closed.Power Supply IC695PSA040 is a 40-Watt supply that operates from an input voltage source in the range of 85 to 264 VAC or 100 VDC to 300 VDC. This power supply provides three outputs: ▪ +5.1 VDC output. ▪ +24 VDC relay output that can be used to power circuits on Output Relay modules. ▪ +3.3 VDC. This output is used internally by RX3i modules with IC695 catalog numbers. Caution Only one IC695PSA040 can be installed in a PACsystems RX3i (IC695 catalog number) Universal Backplane. This Power supply cannot be used with other RX3i power supplies in redundant or increased capacity modes. Power Supply version IC695PSA040C and before may cause equipment damage if inadvertently installed in the same backplane as another RX3i power supply. If the number of modules required exceeds the capacity of the Power Supply, the additional modules must be installed in Expansion or Remote backplanes or power supplies capable of increased capacity mode operation must be used. The Power Supply indicates when an internal fault occurs so the CPU can detect loss of power or log the appropriate fault code.

Four LEDs on the Power Supply indicate: 

▪ Power (Green/Amber). When this LED is green, it indicates power is being supplied to the backplane. When this LED is amber, power is applied to the Power Supply but the Power Supply switch is off. ▪ P/S Fault (Red). When this LED is lit, it indicates the Power Supply has failed and is no longer supplying sufficient voltage to the backplane. ▪ Over Temperature (Amber). When this LED is lit, it indicates the Power Supply is near or exceeding its maximum operating temperature. ▪ Overload (Amber). When this LED is lit, it indicates the Power Supply is near or exceeding its maximum output capability on at least one of its outputs. The CPU Fault Table shows a fault if any Overtemperature, Overload, or P/S Fault occurs. On/Off Switch The ON/OFF switch is located behind the door on the front of the module. The switch controls the operation of the outputs of the supply. It does NOT interrupt line power. A projecting tab next to the switch helps prevent accidentally turning it on or off. Wiring Terminals Terminals for +24V and –24V power, ground, and MOV disconnect accept individual 14 to 22AWG wires.