ABB PMA324BE Serial Link Controller

The GF-1 and the modules in the slots are usually connected with D-Subminiature plug connectors in accordance with DIN 41652. Only use metal or metallised connector casings with a cable clamp for strain relief fastened on one side of the connector. The clamping of the cable shield ensures an optimum contact area and low impedance connection with the connector casing of the GF-1.

The following procedure is recommended for making the low-impedance connection for the cable shield: 

1. Strip the cable 

2. Shorten the exposed shield braid by approx. 3 cm. 

3. Turn back the braid over the cable sheath. 

4. Use a heat shrinkable tubing or insulation tape to cover the exposed cable sheath with the folded back screen braid so that 5 to 8 mm of exposed cable shield is left at the sheath end and is cleanly covered at the back. 

5. Fit the connector. 

6. The cable is then fastened at the exposed shield braid and the cable sheath below it directly underneath the cable clamp strap of the connector casing.

Company product range

----------------------Ruichang Mingsheng Automation Equipment Co., Ltd----------------------

PLC module, programmable controller, CPU module, IO module, DO module, AI module, DI module

Network communication module

Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output

Module, redundancy module, power module, relay output module, relay input module, processor module

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/