ABB KUC720AE KU C720 AE Logic control card

P-CUT connected to GND (normally-closed switch). If this connection is opened, motion is killed and the program in progress is terminated. If the P-CUT input is not grounded when motion is commanded, motion will not occur and the error message “WARNING: PULSE CUTOFF ACTIVE” will be displayed in the terminal emulator.

+5V connected to AUX-P and V_I/O (sourcing current). 

Provides +5V power to the P-CUT pull-up resistor. As an alternative, you can connect AUX-P to an external supply of up to +24V (but do not use both the on-board +5V terminal and an external 5-24V supply). If V_I/O is connected to a +5V supply (on-board or external), AUX-P can be connected to a supply of up to +24V. If V_I/O is connected to an external +24V supply, AUX-P must also be connected to +24V (or to GND). Switching levels depend on the voltage applied to V_I/O: LOW £ 1/3 of V_I/O voltage; HIGH ³ 2/3 of V_I/O voltage NOTE: AUX-P and V_I/O are also used by the HOM, NEG, POS & TRG inputs. SINKING CURRENT: To make P-CUT (as well as HOM, NEG, POS & TRG) sink current, connect AUX-P to GND.

Company product range

----------------------Ruichang Mingsheng Automation Equipment Co., Ltd----------------------

PLC module, programmable controller, CPU module, IO module, DO module, AI module, DI module

Network communication module

Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output

Module, redundancy module, power module, relay output module, relay input module, processor module

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/