ABB PM865K02 PROCESSOR UNIT

Open collector output. Pull-up connection on I/O connector: Connect OUT-P to +5V, or to an external 5-24VDC power supply (but not to both). Outputs will sink up to 300mA or source up to 5mA at 5-24VDC. STATUS: Check with TOUT or OUTFNC. Active level: Default is active low, but can be changed to active high with the OUTLVL command You must select either the on-board +5V terminal or an external power supply to power the IN-P and OUT-P pull-up resistors. Connecting IN-P or OUT-P to the +5V terminal and an external supply will damage the ZETA6104. (The same rule applies to the AUX-P terminal.)

If you will be connecting to a combination of sourcing 

and sinking outputs, connect IN-P to +5V (or to an external 5-24VDC supply) to accommodate sinking output devices. Then for each individual input connected to a sourcing output, wire an external resistor between the ZETA6104’s programmable input terminal and ground (see “R” in above drawing). The resistor provides a path for current to flow from the device when the output is active.

Company product range

----------------------Ruichang Mingsheng Automation Equipment Co., Ltd----------------------

PLC module, programmable controller, CPU module, IO module, DO module, AI module, DI module

Network communication module

Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output

Module, redundancy module, power module, relay output module, relay input module, processor module

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/