The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on.

BENTLY 3500/42M 176449-02 speed monitor

Hold the module by the faceplate and slide it into its assigned slot; push until the rear edges of the module are firmly seated in the backplane connectors. 8. Turn the two latching screws on the module ½-turn to lock the module in place. A module is locked into the module mounting unit when the open end of the slots on the latching screws faces the center of the module faceplate. Termination Unit Replacement Refer to the Communication Termination Unit (NTCL01) and Multifunction Processor Termination Unit (NTMP01) instruction for termination unit step-by-step replacement procedures and spare parts information.The INNIS01 Network Interface module uses the NTCL01 termination unit. Jumpers on the NTCL01 unit select the type of cable used to connect the INNIS01 module to Cnet (or INFI-NET). Refer to the Communication Termination Unit (NTCL01) instruction for complete information. Figure A-1 shows the location of jumpers and connectors. Table A-1 lists the jumper settings used on NTCL01 unit circuit board revision levels D and E. Table A-2 lists the jumper settings used on NTCL01 unit circuit board revision levels F and later. Figures A-2 and A-3 show the coaxial and twinaxial cable connections for nonredundant applications.

Overview

The INICI12 Cnet-to-Computer Interface is a Harmony rack communication interface. It provides a host computer or human system interface (HSI) access to Control Network (Cnet) in the Symphony Enterprise Management and Control System. NOTE: The INICI12 interface is fully compatible with existing INFI 90 OPEN Strategic Enterprise Management Systems using the INFI-NET communication system. The INICI12 interface mainly consists of the INNIS01 Network Interface Module and the INICT12 Computer Transfer Module (Fig. 1-1). This interface gives a host computer access to point data over Cnet along with other control system capabilities. It supports a tag database capacity of 10,000 tags (i.e., point definitions). The computer connects through an RS-232-C serial port that operates at rates up to 19.2 kilobaud. The interface is command driven through software on the host computer. It receives a command from the host computer, executes it, then replies.