The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on.

IC698PSA350D General electric (ge) card

Unpacking and Inspection 1. Examine the hardware immediately to verify that it has not been damaged in transit. 2. Notify the nearest ABB sales office of any damage. 3. File a claim for any damage with the transportation company that handled the shipment. 4. Use the original packing material and container to store the hardware. 5. Store the hardware in an environment of good air quality, free from temperature and moisture extremes and corrosives. Installation and Connection Sequence Figure 3-1 is the INICI12 interface installation and connection flowchart. This flowchart applies whether installing the interface in a new system or in an existing system. In the flowchart, each flowchart block represents a single task. The PR code in the flowchart block identifies the procedure section that describes the steps to complete the indicated task. For example, turn to section PR3 to read about module installation. Some steps are self-explanatory and have no related procedure section. Complete all steps given in a procedure section before continuing to the next flowchart block. The procedure sections are located towards the back of the instruction.

Verify the main power, field power, and power entry panel circuit breakers/switches are turned off before starting installation, retrofit, upgrade, or wiring procedures. Failure to do so could result in severe or fatal shock. Do not turn the power on until the installation, retrofit, upgrade, or wiring procedures are complete. A rack module should not be inserted or removed with power applied when located in a class I, division 2 hazardous location unless the area is known to be nonhazardous.

INNIS01 Network Interface 

Figure 4-1 shows the INNIS01 module faceplate. On power up, the INNIS01 module microprocessor stays in reset until the INICT12 module removes the reset and allows the firmware to execute self-diagnostic routines. The INICT12 module determines when the INNIS01 module will go online. The INNIS01 module comes online in the network mode set by switch SW3, with the type of counter display set by switch SW4. Group A and B LEDs Use the faceplate group A and B LEDs to check the INNIS01 module operation. If communication errors occur, the host module sets the INNIS01 module communication status bits in the module status. View the module status by using a human system interface. Event Counters Internal counters maintain a count of events such as the number of messages transmitted, retries, and number of messages lost. The group A and B LEDs on the module faceplate display a binary value of the event counter selected with switch SW4. LED B8 is the most significant bit; LED A1 is the least significant bit. Refer to Table PR6-5 for a list of event types and their counter addresses.After completing the steps detailed in the installation section, the modules of the INICI12 interface are ready to be put into operation. This section provides the necessary information for daily operation of the modules.