The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on.

140CRA93200 Analog module

Minimize the loading of particulates in the sample by performing a centrifuge spin of the sample plate (e.g. 3000 rcf for 5 minutes) before starting a new run. The debris may be flushed out of the chip by washing and re-priming the chip. See “LabChip Kit Essential Practices” on page 25 for instructions on how to wash and reprime the chip. 4 Check the O-rings on the top surface of the chip interface and clean if necessary.

To ensure proper assay performance, please follow the important handling practices described below.Failure to observe these guidelines may void the LabChip Kit product warranty.1 Note: It is important to keep particulates out of the chip wells, channels and capillary. Many of the following guidelines are designed to keep the chips particulate-free. For assay and instrument troubleshooting, refer to the LabChip GX Touch software Help file or call PerkinElmer Technical Support at 1- 800-762-4000.

General 

• Allow the chip, sample plate, and all reagents to equilibrate to room temperature for at least 30 minutes before use. • Clean the O-rings in the chip interface weekly and the electrodes daily. Refer to the Instrument Users Guide Maintenance and Service section for procedures. • Avoid use of powdered gloves. Use only non-powdered gloves when handling chips, reagents, sample plates, and when cleaning the instrument electrodes and electrode block. • Calibrate laboratory pipettes regularly to ensure proper reagent dispensing. • Only the PerkinElmer-supplied clean room cloth can be used on the chip to clean the detection window. • Water used for chip preparation procedures must be 18 megohm, 0.22-µm filtered water (Milli-Q® or equivalent). • Using the “Reverse Pipetting Technique” (described next) will help avoid introducing bubbles into the chip when pipetting the gel.

Reverse Pipetting Technique

1 Depress the pipette plunger to the second stop. 2 Aspirate the selected volume plus an excess amount from the tube. 3 Dispense the selected volume into the corner of the well by depressing plunger to the first stop. 4 Withdraw the pipette from the well.

Reagents

 • Store reagents at 2 - 8°C when not in use. • The LabChip dye contains DMSO and should be thawed completely before use. It is recommended that you prepare aliquots to reduce the time required for thawing. • Gently vortex all kit reagents before use. • Dispense reagents into chip wells slowly without introducing air bubbles. Insert the pipette tip vertically and to the bottom of the chip well. • Protect the dye and Gel-Dye mixture from light. Store in the dark at 2 - 8°C when not in use. • The Gel-Dye mixture expires 3 weeks after preparation.