YOKOGAWA SC200S Counter module

• Install the noise filter as close to the AC input terminal of DC power supply as possible. Use cable clamps and other means to secure the AC input cables (AWG18: 0.75 mm2 or more) and output cables (AWG18: 0.75 mm2 or more) firmly to the surface of the enclosure. 

• Connect the ground terminal of the noise filter to the grounding point, using as thick and short a wire as possible. 

• Do not place the AC input cable parallel with the noise filter output cable. Parallel placement will reduce noise filter effectiveness if the enclosure’s internal noise is directly coupled to the power supply cable by means of stray capacitance.

„ Wiring the power supply cable and I/O signal cable 

• Use a shielded cable of AWG22 (0.3 mm2 ) or more for the power supply cable of the NETC01-M2, and keep it as short as possible. 

• For the MECHATROLINK-II communication cable, use a dedicated cable with connector. 

• To ground the power supply cable , use a metal cable clamp or similar device that will maintain contact with the entire circumference of the cable. Attach a cable clamp as close to the end of the cable as possible, and connect it as shown in the figure.

Professional seller

Professional sales of major electrical brand products in the world

Overseas direct purchase of products, authentic inventory, p

rice concessions

After sales warranty, complete models, same products, different prices and services

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/