GE DS200TCEAG1BSF DS215TCEAG1BZZ01A contact module

The P3 connector is for a single 3.5" floppy drive and the P5 connector is for a single 3.5" floppy drive of the type found in many laptop computers. Both of these connectors are routed to the same signal lines on the P2 connector, so one may be used at a time. Similarly, the P1 connector connects up to two standard 3.5" hard drives and the P4 connector connects up to two 2.5" hard drives. Both of these connectors also use the same P2 connector signal lines, so only one may be used at a time. The XVME-973/1 is shipped with cables for the P1 and the P3 connectors. The pinouts in this chapter may be used as references to make cables for the P2 and P4 connectors.

The IDE controller supports enhanced PIO modes

which reduce the cycle times for 16-bit data transfers to the hard drive. Check with your drive manual to see if the drive you are using supports these modes. The higher the PIO mode, the shorter the cycle time. As the IDE cable length increases, this reduced cycle time can lead to erratic operation. As a result, it is in your best interest to keep the IDE cable as short as possible. The PIO modes can be selected in the BIOS setup (see p. 36). The Autoconfiguration will attempt to classify the connected drive if the drive supports the auto ID command. If you experience problems, change the Transfer Mode to Standard.

Payment method and delivery

Shipment: EMS,DHL,UPS & FEDEX

Payment: T/T or Western Union

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/