GE DS200TCQAG1BED Voltage monitoring module

Follow these steps to install the SODIMM: 1. Follow standard antistatic procedures to minimize the chance of damaging the XVME-660 and its components. 2. Power off the XVME-660, remove it from the VME backplane, and place it on a safe antistatic (grounded) surface. 3. Remove all connectors if not already removed. 4. Remove the daughterboard gently pulling it up at the back and backward so that the IP, SCSI, and PMC (if any) connectors are pulled out of the front panel. Put the daughterboard to the side.

Pull the metal clips on either side of the SODIMM until it pops up at an angle

from horizontal). 7. Grasping the upper two corners or the edges of the SODIMM, gently pull it out of the socket and set it to the side. 8. Insert the new SODIMM until it fits snugly into the connector. 9. Gently push the SODIMM down until the metal clips snap into place to hold it. If you cannot gently push the SODIMM into position, you may need to redo step 8. 10. Replace the daughterboard.

Payment method and delivery

Shipment: EMS,DHL,UPS & FEDEX

Payment: T/T or Western Union

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/