REXROTH 0608801006 Ethernet interface module

It is strongly recommended to use pulse-width-modulation (PWM) as input signal to coils rather than straight DC. Our tests indicate that PWM input signal allows best valve performance, significantly reducing hysteresis and response times of all our proportional valves. All features shown and explained in next pages are available from many industry-common electronic controllers, including Proportional Controllers described in this catalogue

CH recommends to use always 12 V DC coils 

in combination with 24 V DC supply voltage to the electronic controller. This allows to use a much wider control current range independently from coil temperature, since anyway current is regulated by the electronic controller and there is no coil overheating risk. c. in order to prevent air form collecting in the magnetic tube the valve should be mounted below the reservoir oil level. d. if this is not possible horizontal installation will give the best results. e. do not switch the valve unless properly installed in an oil filled circuit

Payment method and delivery

Shipment: EMS,DHL,UPS & FEDEX

Payment: T/T or Western Union

Application industry

Our main products are widely used in metallurgy, oil and gas, glass manufacturing, aluminum, petrochemical, coal mine, paper making and printing, textile printing and dyeing, machinery, electronic manufacturing, automobile manufacturing, tobacco, plastic machinery, electricity, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution, etc.

This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/