DDK SAN3-24 Sequential control module
Equipment required for all relays – dc voltmeter to check nominal dc volts. – ac voltmeter to cover setting range. – resistance meter. – electronic timer. – double pole switch (except for MVTD 01)Ensure that the correct series dropping resistor(s) are fitted if required. Remove the relay from its case and check that the incoming dc supply at the relay case terminals 13(+ve) and 14(–ve) is within the range specified below.
Warranty: 365 days Goods status: new/used Shipping method: Courier delivery
Company product range
----------------------Ruichang Mingsheng Automation Equipment Co., Ltd----------------------
PLC module, programmable controller, CPU module, IO module, DO module, AI module, DI module
Network communication module,
Ethernet module, motion control module, analog input module, analog output module, digital input module, digital output
Module, redundancy module, power module, relay output module, relay input module, processor module
Test block type MMLG
If a test block is included in the scheme, it may also be associated with protection CT circuits. It is important that the sockets in the type MMLB 01 test plug which correspond to the current transformer secondary windings are LINKED BEFORE THE TEST PLUG IS INSERTED INTO THE TEST BLOCK. DANGER: DO NOT OPEN CIRCUIT THE SECONDARY CIRCUIT OF A CURRENT TRANSFORMER SINCE THE HIGH VOLTAGE PRODUCED MAY BE LETHAL AND COULD DAMAGE INSULATION. The test plug isolates test block terminals 13 and 15 from 14 and 16 respectively removing the dc supply, making it necessary to add links between these terminals to restore the auxiliary supply to the relay.
This article from the temporal Ming sheng automation equipment co., LTD., reproduced please attach this link: http://www.stockdcs.com/