The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

DS200SDCCG5AHD Gas turbine module

Before installation, switch off the mains supply to the ACS 600. Wait five minutes to ensure that the intermediate circuit is discharged. Switch off all dangerous voltages connected to the inputs or the outputs of the ACS 600.

ACS 600 Connection Ensure that the UDC+ and UDC– busses are properly connected to the corresponding terminals of the ACS 600 (see Chapter 3 – Voltage Selection and Mechanical Installation). Note: The braking chopper must be earthed to ACS 600 chassis by connecting a separate wire between a chopper earthing terminal and an ACS 600 chassis terminal (see Figure 4-4 on previous page). Resistor Cable Connection Connections at the braking resistor: (For terminal tightening torques, consult resistor documentation.) • Twist the screen wires together and connect them to the earthing terminal, along with conductor no. 3 (if present). • Connect conductor no. 1 to the R– terminal. • Connect conductor no. 2 to the R+ terminal.

Connections at the braking chopper:

Figure 4-5 Resistor cable stripping diagram (braking chopper end). All lengths are approximate. • Cut and strip the cable as shown in Figure 4-5 above. • Lead the cable through the cable entry into the converter unit. • Slip the copper sleeve (inserted into the earthing clamp at the factory) onto the outermost insulation of the cable so that insulation and sleeve edges are aligned (see Figure 4-4). • Bend the screen wires evenly backwards onto the copper sleeve. • Unfasten the screen earthing clamp and slip it onto the screen wires at the copper sleeve. Replace the clamp and tighten the fastening screw to 3 Nm. • Twist the screen wires together and connect them to one of the earthing terminal posts on the chopper as shown in Figure 4-4. Tighten the terminal to 1 Nm.

• Connect conductor no. 3 (if present) to one of the earthing terminal posts on the chopper as shown in Figure 4-4. Tighten the terminal to 1 Nm. • Connect conductor no. 1 to the R– terminal. Tighten the terminal to 1 Nm. • Connect conductor no. 2 to the R+ terminal. Tighten the terminal to 1 Nm. • If a clamping cable gland is used at the cable entry, tighten it only after making the terminal connections.